TC-160 LIGHTNING

TC-160 LIGHTNING 12V ELECTRIC UNDERTAILGATE SPREADER. All TruckCraft spreaders carry two year factory warranties. Made of tough, corrosion resistant T6 Aluminum alloy and stainless steel you get the best of both worlds, weight savings and extreme durability in high-salt conditions. And check out innovative designs by TruckCraft, such as the completely enclosed 90 degree-angled gear reducer on the SPINNER DRIVE. It not only provides maximum road clearance by positioning the motor up, horizontally, but the 2:1 gear reduction doubles torque, allowing you to slow the spinner wa-a-ay down without sacrificing torque. Heavy, factory assembled wiring harnesses carry power from the USA-made Electronic Control Unit to the enclosed, LEESON WASH_DOWN GRADE motors, made with type 304 stainless shafts, double seals, epoxy coating, and sealed housings. It doesn't get any beefier than this. See one at your local TruckCraft dealer now!

All electric - needs no hydraulic system
3/4 HP auger drive empties 15,000 lb/hr*
1/6 HP spinner motor in protected housing
Kit fits virtually any one-ton dump body
Constructed of extruded T-5 alloy & aluminum sheet for durability
Installed unit weight - 275lbs
Backlit, fused, 100 AMP motor controller*
Auto-level spinner requires no linkage
Right angle spinner motor drive provides higher motor road clearance
Stainless steel auger, spinner & Harware
All bolt-on kit installs in 5 hours
Auger reducer is in-line premium helical gear type for 98% efficiency
Spreads free-flowing mat'l up to 3/4" dia.
Two year factory warranty
*150 AMP Alternator recommended for 15,000# output

88" WIDE MODEL
96" WIDE MODEL

TC-160 Lightning Brochure 5.5MB
TC-160 LIGHTNING SPECS June 2008
Owner's Manual 2007+ ( 5 MB file)
Owner's Manual PRE 2007 ( 5 MB file)